12/29/2022 0 Comments Cut gain mixbus![]() ![]() This is the time that the Gate/Expander will delay before the release will start to close. Hold – Sets the Hold time for the Gate/Expander.This is the time that the Gate/Expander will take to go from closed (attenuated) to fully open (non-attenuated). Attack – Sets the attack time for the Gate/Expander.Control allows for 3dB to 60dB of attenuation. Range – Sets the amount the gate would attenuate the channel once the level has passed below the Threshold.This is the level at which the gate would start to attenuate the channel. Threshold – Sets the Threshold of the Gate/Expander.Type – Allows you to select between Duck, Gate, EXP2, EXP3, and EXP4.Active – Turns on and off the Gate/Expander.Right and Left controls the threshold, up and down controls the range. If you press and drag on the graph, you can set threshold and range at the same time. The Gate tab controls the Gate and Expander function of the X32. Mono/C Fader – Allows adjustment of channel send into the Mono/C Bus.Mono/Center MONO/C – Assigns the channel into the Mono/C Bus.Main Stereo LR – Assigns the channel into the Main LR Bus.Automix Weighting – This is a control of the Automix feature of the board, this will allow you to give more weight to a channel to allow it to always be louder or quieter than the other channels in the same automix group.Automix Group – This is available on channels 1-8 and control which automix group the channel will be assigned to.Mute Groups Assignment – Let’s you assign the selected channel to any of the Mute Groups 1-8.DCA Assignment – Let’s you assign the selected channel to any of the DCA’s 1-8.Copy/Paste – This is one of my favorite features, it allows you to copy and paste channels with the ability to choose the scope of paste (Head Amp, Configuration, Gate, Compressor, Equalizer, Sends).Low Cut – Turns on and off the Low Cut, or High Pass Filter.Delay – Turns on and off the channel input delay, and allows for delay adjustment of 0.30ms to 500ms.Gain – Allows you to set the input gain of the channel.48V – Turns on and off +47V Phantom Power for the channel input source.Phase – This changes the polarity of the channels audio.Link – Links the odd/even channel pair.Insert – Allows adding an insert for the selected channel. ![]() INS accounts for the physical insert of the channel. Pre/Ins/Post – Pre and Post account for the insert being Pre EQ/Dynamics or Post EQ/Dynamics.Swap – Swaps the position of Dynamics to Pre-EQ or Post-EQ.Source – Sets the input source for the channel.The Config/Preamp tab has a TON of settings on it, here is the list of settings that it controls: This is going to be the tab that covers all of the main adjustment of each channel. This week I want to go over the meaty portion of the application, the ‘Detail Tab’. ![]() Cut gain mixbus series#Last week I started my X32-Mix App Tutorial series with the Home Tab, if you haven’t seen the blog post, check it out here: X32-Mix App Tutorial Home Tab. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |